Replacing rear seals - 2003 Club Car
How difficult is it to replace the rear seals in a 2003 Club Car? While replacing my rear brakes, I discovered oil all in the drum area on the right side. I couldn't find any Youtube videos. Can you get a book to help with maintenance?
|
Re: Replacing rear seals - 2003 Club Car
1 Attachment(s)
It's relatively easy - I did mine early last year....BUT ONLY IF YOU HAVE THE CORRECT RIGHT ANGLE CIRCLIP PLIERS. Otherwise it's a real bear without the right tool. The seals remove, and the new ones tap-in-place easily, once the axle is pulled.
|
Re: Replacing rear seals - 2003 Club Car
1 Attachment(s)
Here's an old drawing showing location of the circlip.
|
Re: Replacing rear seals - 2003 Club Car
Thanks joesam. I appreciate your help. I have some retaining ring pliers but not 100% sure they will fit. I will check in a bit. Thanks again.
|
Re: Replacing rear seals - 2003 Club Car
I downloaded the service manual pdf and that helps a lot. Did you have to use a bearing puller to get the old seal out?
Quote:
|
Re: Replacing rear seals - 2003 Club Car
Nope. They can be gently levered out with a wide flat screwdriver. They are not a press fit.
I tapped the new ones back in with the wood handle of a hammer. |
Re: Replacing rear seals - 2003 Club Car
Thanks again. I will get back to this project tomorrow.
Quote:
|
All times are GMT -5. The time now is 07:08 PM. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This Website and forum is the property of Buggiesgonewild.com. No material may be taken or duplicated in part or full without prior written consent of the owners of buggiesgonewild.com. © 2006-2017 Buggiesgonewild.com. All rights reserved.