rebuilt starter now running backwards
 

I put new brushes and sanded the armature. Everything look very good but I did not mark the wires where they came from. I found some info on line that put the jumper wire F1 to A2. A1 neg and F2 pos. This spins the motor ccw on the pulley end of the starter. The gas engine has an arrow on it that shows it needs to spin cw. I get a lot of load barking out the intake so bad I can not hold my hand over it. I opened the valve cover and it look like the valve were working normally and not being held open as I first thought.

Re: rebuilt starter now running backwards
 

per what i read on here, you can change rotation on the starter via swapping wires on A1 and A2 terminals

do a search on here, been discussed a few times especially with the cw/ccw club cars !!

main concern is wear on brushes if they have been running and worn in one direction

Re: rebuilt starter now running backwards
 

Need to move the green wire to A1 - F1.
Negative to A2.

Wire diagrams here: http://i.imgur.com/Q9WsMs7.jpg?2