Electric Lift for Workhorse dump bed
 

Don’t know if this is worthy of a sticky?
Electric lift for workhorse dump bed components that will seamlessly fit factory mounts.

Warner Electric liner actuator# K2xG20 (2200 lb cap, 6” throw) You can use any that is 14” to 15” closed dimension.

Napa switch# TG7071 (Momentary on /off/ momentary on 6 pole)

Napa 30amp breaker# 782-3105

1) ½” x 3” clevis pin
1) ½” x 1-7/8 to 2” clevis pin
2) 3/8” spacers (I used 1/2" SAE washers)
3) cotter pins (appropriately sized for clevis pins)

Red and black primary wire, I used 14 gauge about 15’ ea.
15’ 1/2” split loom cut to length.

cost me ttl $143.00

Re: Electric Lift for Workhorse dump bed
 

Sticky

Re: Electric Lift for Workhorse dump bed
 

Where did you get the actuator from?
I'll make this a sticky or part of one asap.

Re: Electric Lift for Workhorse dump bed
 

Ruredy,
I got mine on e-bay real cheap. You would have to find a Warner distributor to buy them retail.
I also think the Northern Tool Item# 125011 will work, I just thought it was kind of cheap looking.

Re: Electric Lift for Workhorse dump bed
 

Jon,

This is the Warner page for the actuator. They have a link on top for dealer locator.
http://www.warnernet.com/newproducts...gory=actuators

Re: Martini Time No Subject
 

Switch wiring for ez-go dump:thumbup: