Overtighten
 

Any suggestions on how to tighten 4 nuts on the 4 copper lugs on the F&R Switch without snapping them?

Matt

Re: Overtighten
 

A thumbwheel ratchet. If you're snapping them off by snugging them up with an average 1/4" drive, they have likely annealed themselves from overheating, and are now softer and more malleable than they were designed to be.

Re: Overtighten
 

Ok I fixed it all up Good Today...(Without Snapping....clap..clap) Lol. Bought a brand new cam assembly. I should mention that nothing was getting hot I was bored and decided to "Fix - It". It runs great. I used it from 9:00am to 5:00pm. I also added a Toolbox to it and I drilled the holes myself and bolted it to the rear. I got the toolbox from an old Yamaha Cart that no longer runs or will ever run again. -_-. I will post pics. Me and my brother used it all day to pull scrap metal out of the woods. We also pulled an Old van out of the woods. The golf cart was strong enough for that. Good thing it was only for 15 seconds because the motor was starting to get hot. Gonna haul more metal from the woods morning until night tomorrow and I will report back. It turns out 4 8Volt Batterys lasted me about 8 hours. That good enough for me because most of the time we dont drive it all day only small parts of the day off and on.

Matt

Re: Overtighten
 

pictures going up tomorrow
;)