08 ez go rxv won't do any thing
 

It just stopped running, solenoid won't click, when you jump the solenoid the motor turns over but won't run because it has no spark, replaced the solenoid and still nothing

Re: 08 ez go rxv won't do any thing
 

Wow this is a common theme today.....id suggest sending 12VDC+ to the small positive terminal on the solenoid. If it clicks and cranks you got one of a few things, blown fuse on the wire going to the switch from the solenoid, bad/misaligned pedal limit switch, bad ignition switch. If it doesn't crank you could be looking at a bad solenoid Or a dead battery among other issues

Re: 08 ez go rxv won't do any thing
 

Just tried that, it clicks but dosnt crank

Re: 08 ez go rxv won't do any thing
 

Well if your jumping the two main (large studs) and the motor is cranking when the solenoid changes state into a closed position by sending 12 volts directly to the coil it should also crank at that point. I need to ask you did hear the solenoid clicking and not the wire arcing correct? How are your ground connections? Was your replacement solenoid new? Can you bench test your old solenoid by sending 12vdc to the coil and throwing an ohm meter across the main terminals? Just curious if the old one was actually bad or not. Can you send a picture of your replacement solenoid all hooked up? Get another few sets of eyes on your wiring?

Re: 08 ez go rxv won't do any thing
 

I'd say check the fuse at the solenoid. Check voltage at solenoid, battery etc

Re: 08 ez go rxv won't do any thing
 

It ended up being the fuse, but what made the fuse blow??

Re: 08 ez go rxv won't do any thing
 

Well you did replace the solenoid, it's possible that the old one failed and blew the fuse.....run it see how she does and carry a spare fuse with you for a while