Need definitive answer about Plowman's posi-trac unit!!
Plowman's carts posi unit is considered to be the best - and I would so love to order one. However...
Their website states the following on the posi-trac unit: "Designed to fit 1998 to 2006 EZ-GO electric and 1998 to 2006 gas and electric Yamaha." I have a 2008 EZGO, but isn't the rear axle exactly the same on a 2006 and 2008?? I've called them and they don't have the answer - they just told me "We're mainly Yamaha guys". Anyone? |
Re: Need definitive answer about Plowman's posi-trac unit!!
Anyone?
|
Re: Need definitive answer about Plowman's posi-trac unit!!
as far as I am aware, there is no change in the rear end on the 2008.
|
Re: Need definitive answer about Plowman's posi-trac unit!!
Thanks!! I really want to get the cart to posi-trac, and don't want to weld the rear end. Just want everything done to it I can to help out when the time comes and it drops down into some deep mud. I know me, it will happen, sooner rather than later :help:
How hard are these too install? Do I have to drop the rear end or can all of this be done with the bottom cover removed? |
Re: Need definitive answer about Plowman's posi-trac unit!!
Just tried to order the posi unit - was told they make/carry no parts for EZGO.
Told him about the website and what it says, put me on hold for a minute or two, and said to call back on Friday, that the person I need to talk to isn't in. |
Re: Need definitive answer about Plowman's posi-trac unit!!
ouch... I don't have the Plowmans unit but I do have one of these.....
http://www.nivelparts.com/pages/prod...&n=Accessories I usually pull the rear end when installing these personally. |
Re: Need definitive answer about Plowman's posi-trac unit!!
lizard, i bought mine from plowmans. you need to talk to don, the owner. they are easy to install. if you need any help, let me know.
|
Re: Need definitive answer about Plowman's posi-trac unit!!
After a week of leaving messages, finally got Don on the phone and ordered my unit, and the oil he recommended.
madoc - so how hard is it to install one of these puppies? |
Re: Need definitive answer about Plowman's posi-trac unit!!
3 Attachment(s)
not hard at all. pull the pan and then the axles need to be pulled back about4-5'. just pull the drum, then take off the retaining clip. you can reverse the drum and use it like a slide hammer. this is hardest part. then take the 4 bolts holding the ring gear and spiders in and the they will drop out. take off the ring gear and diassemble the spiders. sand smooth the inner faces of the two side spiders, and reassemble. all done on the bench, once it is out.
|
Re: Need definitive answer about Plowman's posi-trac unit!!
Thanks for the pics!! How much of a difference did you notice in the way it handles the high torque loads i.e. mud, slush, etc?
|
All times are GMT -5. The time now is 01:27 AM. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This Website and forum is the property of Buggiesgonewild.com. No material may be taken or duplicated in part or full without prior written consent of the owners of buggiesgonewild.com. © 2006-2017 Buggiesgonewild.com. All rights reserved.