Alltrax xct throttle calibration
I just got my controller installed and I'm having issues with my throttle. Cart is in my sig. MCOR4 conversion has been done and throttle worked fine before the swap. Now when I watch the throttle on the monitor page, it's showing 100% at hardly any pedal. I can't find where on the alltrax software to do a throttle learn. It will drive but only if I just lightly press the throttle.
|
Re: Alltrax xct throttle calibration
Looking at it now my throttle is actually working backwards. When it is on the floor it is showing 0% and when barely pressed it shows 100%
|
Re: Alltrax xct throttle calibration
What throttle do you have selected in the software. It should be MCOR 5k-0 ohms.
|
Re: Alltrax xct throttle calibration
Quote:
http://www.buggiesgonewild.com/elect...al-issues.html |
Re: Alltrax xct throttle calibration
Quote:
Time to see what speeds i can get |
All times are GMT -5. The time now is 09:58 PM. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This Website and forum is the property of Buggiesgonewild.com. No material may be taken or duplicated in part or full without prior written consent of the owners of buggiesgonewild.com. © 2006-2017 Buggiesgonewild.com. All rights reserved.