anerobic sealer
I used some anerobic sealer on my crankcase halves several days ago and it is still not cured. Does this stuff stay tacky or should it dry like silicone? It is the red permatex brand.
|
Re: anerobic sealer
An anerobic sealer only dries in the absence of air, like locktite. This means that the stuff that has oozed out will not dry. This may have been a poor choice for crankcase halves as the stuff that oozed out on the inside will not harden and could possibly get loose and clog an oil port. I have seen liquid gasket maker do just this. Google anerobic sealer to read more about it.
|
Re: anerobic sealer
The sealer I used is what I was told to use on this forum. Some where in a shop manual it says to use it, so I was told, because it it impervious to gasoline. What would have been a better choice in your opinion? I had assumed the members that suggested it had used it with good results.
|
Re: anerobic sealer
it works fine , it seals under pressure torque to the spec's, whatever leaked out wipe away and you should be fine....
|
Re: anerobic sealer
What leaked out on the inside is still there because I couldnt get in there to wipe it out. The engine is back in the cart, so I really dont want to pull it back out and pull it apart unless this sealer is going to be a problem. Since it is a thick gel it may not matter.
|
Re: anerobic sealer
It is just my opinion. I do not use that stuff. A friend who did use it had a problem with it so I was just passing that on... pretty sure somebody else has a different opinion.
Maybe we can get some others to weigh in on the whole anerobic sealer question. |
Re: anerobic sealer
So what are you supposed to used to seal case halves that have no gasket?
|
Re: anerobic sealer
i have used the grey permatex sealer which they advertise for use on motorcycles and snowmobiles, etc. it is brushed on for a thin coat.
after a couple of minutes, assemble. any squeazed out sealer dries to firm but not hard substance. grey also shows very little. jim |
Re: anerobic sealer
Its expensive but I use Yamabond. Its a grey sealer for crank halves and seals the highest crankcase pressures we can throw at it.
|
Re: anerobic sealer
Grear, thanks for the advice.
|
All times are GMT -5. The time now is 03:31 AM. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This Website and forum is the property of Buggiesgonewild.com. No material may be taken or duplicated in part or full without prior written consent of the owners of buggiesgonewild.com. © 2006-2017 Buggiesgonewild.com. All rights reserved.