EZGO charger cuts off before full charge
 

Model # 26984 Total Charge III. I got this charger used and put an old yellow two prong plug onto the charger as I am using it on our 1975 Cushman (I put this in the EZGO section since I believe it is a charger problem). For awhile the setup worked fine, but eventually the yellow cushman plug started falling apart from age, and then finally I got a bad loose connection that melted it (I could plug it in and wiggle it around and it would stay on and work). During the end of this plug's life I went back once to hear the charger rapidly cycling on and off, and the plug was extremely hot. This is when I decided to bite the bullet and get a new plug.

I ordered anohter plug, installed it, and tried it out. The charger seemed to work fine at first, but now when I plug the charger in, it clicks on for a second or two (meter goes to 20 amps) and the clicks right back off again. Jiggling plug does no good, plug fits tightly into receptacle. I took the cover off of the charger and the MOV 2 Varistor was gone, and one of the wires on the capacitor was loose (touched it and it came loose) and looks like I had some arcing in both places. I reattached the wire to capacitor and no change, although I did plug/unplug the charger a few times tonight and ONCE it stayed on for a few min. When I unplugged/ re-plugged it was back to 1-2 seconds then shuts off.

Batts read 37.7 volts BEFORE I put the pack on a 12V trickle charge for a couple of days (2 at a time) and they were all fairly close in voltage in the low 6's (this was after playing 18 holes twice, while the charger was apparently not staying on long after I left the shed).

Anyone have any suggestions on what this could be?

Thanks!

Re: EZGO charger cuts off before full charge
 

Bueller.....Bueller................Bueller?

Re: EZGO charger cuts off before full charge
 

Ok, this morning to went out and took the plug/ wire off of our EZGO cart, and wired it onto this Total Charge III, then plugged it into the EZGO cart. Same thing. Clicks on for a second or two then clicks back off again. I swapped capacitors from one charger to the other and no change, so I KNOW it's the charger, and I know it's not the capacitor or the fuse. That leaves the control board, diodes, and the transformer. Anyone have any other ideas on what could be causing this? I'd rather not take it to a repair shop, but I'm guessing that's where we will end up with it.

Re: EZGO charger cuts off before full charge
 

Hopefully someone here will come along soon and help you out.

.......and WELCOME to BGW :thumbup:

KEV

Re: EZGO charger cuts off before full charge
 

I say take it to a repair shop before you cause any damage...

Re: EZGO charger cuts off before full charge
 

What he said ^^^^^.....these things are to $$$ to mess up:wink:

Kev

Re: EZGO charger cuts off before full charge
 

Either the relay is bad or the whole board. I bypassed the relay and the charger came on and stayed on until I unplugged the charger. Is this one of those "too good to be true" things? New board, $39 shipped, with warranty?

http://cgi.ebay.com/ebaymotors/ws/eB...K%3AMEWAX%3AIT