97 ds regen 1 no go
 

I have a 97 ds regen 1 that a buddy rode into high water and died immediately after. At first i suspected obc was done but since i have been checking not so sure. I am pretty sure when i checked the very next morning i had battery pack voltage on stem with yellow wire of 50.4v. Now am only getting about 3.7. My resistance across wipers is good with max of 5.7 ohms and the only solenoid that clicks at any time is the one most inner. I can put in fwd and feel wheels jump, also tested with 12v and motor does spin, anyone please? Thanks

Re: 97 ds regen 1 no go
 

Did water get to the controller? That would be my first concern on the R1

Re: 97 ds regen 1 no go
 

Of course he says it never got that high but am really concerned it in fact did, do you know which pin outs/ in i could check to verify operation? Like i said at first i thought i read pack voltage on post at v glide but was furious and was just digging. Yellow shouldn't have pack voltage down there at v glide correct? If you know of the pins to check, please let me know

Re: 97 ds regen 1 no go
 

Pin outs on controller(ooops)

Re: 97 ds regen 1 no go
 

there is a great wiring diagram in the CLUB CAR parts manual for this year, its even got the pin out layout. A pdf file from Mobilicab is a valuable tool.

Re: 97 ds regen 1 no go
 

Will check that out, thanks lab rat!

Re: 97 ds regen 1 no go
 

Went and found web site but no specifics for pins, anyone have anything else?

Re: 97 ds regen 1 no go
 

Does your have the 14 pin "Z" connector?

Re: 97 ds regen 1 no go
 

yessir

Re: 97 ds regen 1 no go
 

Here you go.....

Tread softly. That old controller is VERY cantankerous.... :thumbup: