Access panel
In the bag well of my 2009 Club Car there is an access panel that is held in place by 2 "plastic" pins. How do I remove these pins so that I can take off the access panel? Once this panel is removed I can get to the motor.
|
Re: Access panel
Some of them on a precedent : Look real close at the round pins in the middle. There should me a groove that you can stick the tip of a small straight blade screwdriver partially in, and then you can wedge the pin out a ways. Once the pin is pulled out a ways, you should be able to grab the entire round pin and pin retainer, and pull the entire thing out. Pretty easy if you try it.
Look for the groove, it should be there , unless someone has put some other piece in there. |
Re: Access panel
Not sure if it is a DS, but on mine that is just a protective plastic cover. Once removed, it is just the body. There is the access panel above that and it rolls over the transition. It has a couple of phillips head screws in it. That one can be removed and provides access to the top of the motor and the controller/solenoid area.
|
Re: Access panel
Smokey Tennis Shoe, You were right. Mine didn't have a groove in the head but I was able to grab the head with my pliers and pulled the pins out. When I removed the panel there was my motor like I thought. Thank you for your help.
|
Re: Access panel
|
Re: Access panel
Crash Test Dummy, Thanks for the pictures. Mine is a Precedent with the rivets. I didn't want to pull on them until I knew what they are.
|
All times are GMT -5. The time now is 08:42 PM. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This Website and forum is the property of Buggiesgonewild.com. No material may be taken or duplicated in part or full without prior written consent of the owners of buggiesgonewild.com. © 2006-2017 Buggiesgonewild.com. All rights reserved.