93 club car solid state upgrade (36v) am I doing this right?
2 Attachment(s)
I have a 93 club car (solid state system) that Iam ready to do some upgrades too. from what i can tell it's all stock. I wanted to do the speed controller 1st. any help will be appreciated!
my plans are as follows: 1. plum quick bandit upgrade (still trying to figure out what motor I have see pic any advice is greatly appreciated not sure if it is the ge or AMD mentioned on plum quicksilver site) 2. speed controller (will be based on motor) w/ solenoid 3. I have just purchased 6 new trojan batteries [ATTACH]Attachment 185314[/ATTACH] |
Re: 93 club car solid state upgrade (36v) am I doing this right?
Welcome baconhulk. Look above and click on "Site Sponsors." Find "Revolution Golf Cars." Contact Dave there. He is our expert on these carts and will hook you up with what you need and the best advice. :thumbup:
|
Re: 93 club car solid state upgrade (36v) am I doing this right?
I'm getting close to wrapping my wiring up on this. what gauge wire should I go with for the forward, reverse and solenoid wire (smaller wires)
|
Re: 93 club car solid state upgrade (36v) am I doing this right?
2 gauge welding cable; 600 strand count.
|
Re: 93 club car solid state upgrade (36v) am I doing this right?
Quote:
|
Re: 93 club car solid state upgrade (36v) am I doing this right?
Quote:
|
Re: 93 club car solid state upgrade (36v) am I doing this right?
Quote:
|
Re: 93 club car solid state upgrade (36v) am I doing this right?
thanks for all of the replies guys! that was quick. @haulna$$ I stayed with 36v because I will likely get to use it on occasion and the wife will probably be driving it the most. I ended up not going with the plum quick motor. just changed the solenoid, speed controller, batteries and wiring for now...
|
Re: 93 club car solid state upgrade (36v) am I doing this right?
still trying to get this thing wired up. does anyone have a wiring diagram that shows an sr400 wired up to a 93 solid state? I feel like I'm missing wiring and also have a few that I cannot figure out were they go. I was told the M- to A2 would be deleted. Also trying to figure out where the j4 and j5 go exactly.
|
Re: 93 club car solid state upgrade (36v) am I doing this right?
2 Attachment(s)
There are several ways to wire your cart. I have attached one way to do I’d which is probably the easiest way and works well as long as the V-Glide is working properly and adjusted to remove any slack in the throttle and engage all the contact pads properly. You also need to add a straight jumper wire from post 2 to post 3 as shown in the second pic. HTH
|
All times are GMT -5. The time now is 07:54 AM. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This Website and forum is the property of Buggiesgonewild.com. No material may be taken or duplicated in part or full without prior written consent of the owners of buggiesgonewild.com. © 2006-2017 Buggiesgonewild.com. All rights reserved.