|
Yamaha G14/Predator 420 throttle cable setup???
Has anyone already done a Predator 420cc to Yamaha G14 throttle linkage hookup? I think there’s an easy answer out there but I’m really struggling with this one. Please help, this is the last piece of my engine swap.
-Thanks in advance |
Re: Yamaha G14/Predator 420 throttle cable setup???
Are you running the accelerator pedal cable directly to the carb?
Or are you still going to use the governor on the transaxle? Can you post a photo? |
Re: Yamaha G14/Predator 420 throttle cable setup???
I bumped up my clone throttle thread in the clone big block section. I have a yamaha G 14 with a VC 460 clone engine. If you follow the thread pics show the original install with the governor cable and later just running right from the gas pedal.
|
Re: Yamaha G14/Predator 420 throttle cable setup???
Just an FYI, Predator engine throttle setups are very much different than a Vegas Carts engine. Much more linkage to deal with, especially with the stock governor intact. There are little tricks to deal with the factory governor if you aren't ready to take the engine apart and you have good throttle discipline.
|
| All times are GMT -5. The time now is 05:29 AM. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This Website and forum is the property of Buggiesgonewild.com. No material may be taken or duplicated in part or full without prior written consent of the owners of buggiesgonewild.com. © 2006-2017 Buggiesgonewild.com. All rights reserved.