1979 EZGO Electric missing parts
 

Firstly a big thank you to all of you who have posted info on here already, i at least now know whats missing from my cart! Its a 1979 electric resistor model, but only the motor,f/r switch,ign and an isolator switch and some of the cables are present!
Basically i want to get the cart up and running but without spending a fortune,has anyone modified one of these to run a different motor/speed control that maybe easier to source parts for in the UK? Any advice would be greatly recieved.
Regards
Matt.

Re: 1979 EZGO Electric missing parts
 

If you have a cart junk yard around close just buy anything in the late 80's range with the controller and stuff to swap out into your cart. Old Marothone controller, pot, F/R handle linkage all from a 89 Ezgo. Get all of the parts that you can.
Your motor and F/R switch should work.:thumbup:


http://216.77.188.54/coDataImages/p/...8/DSC02787.JPG

Re: 1979 EZGO Electric missing parts
 

Thanks for reply, i have phoned a guy in the UK who has some knowledge and spares for ezgo... He mentioned that he had some old spares for early eightys carts so maybe i will be in luck!

Re: 1979 EZGO Electric missing parts
 

Anything before 89 will not have the controller I don't think. 1989 was the around the time they started doing away with the coils.:thumbup:

Re: 1979 EZGO Electric missing parts
 

Thanks again, i understand the relevance of the photo now! (its 11.30 pm here and i've been doing my accounts all night!) If the guy dos'nt understand what im after then i will direct him to the picture.
:thumbup:

Better test the motors ok as well before ordering any bits otherwise back to the drawing board! That said i do know for a wrecked Honda Fireblade that has a good engine...

Re: 1979 EZGO Electric missing parts
 

Crimmeny bloke you will drop more than the
royal wedding stuffing that 10000 cc in a cart.