20484 charger dead
Charger. 20484. Ac to primary is good but nothing out of the secondary. Hums. Ohms check is about .3 ohms on secondary. Any ideas?
|
Re: 20484 charger dead
Ps control board is bypassed
|
Re: 20484 charger dead
3 Attachment(s)
Bad diode(s), or circuit breaker tripped/bad, or ammeter bad.
Use an AC voltmeter to measure output across total secondary. (test probes on the wires that attach to the diodes.) Warnings: 1. Pull AC plug from wall outlet while disconnecting/reconnecting capacitor wires. 2. Discharge capacitor and be very careful disconnecting and reconnecting its wiring, it has about 500V on it. With capacitor disconnected, plug in charger. You should get between 55VAC and 65VAC. If you don't, the transformer is bad. If you do, unplug charger, reconnect the capacitor, plug in charger. You should get between 83VAC and 97VAC. If you don't, replace the capacitor with the one having the same µF value. If you do, the transformer and capacitor are withing specs, troubleshoot diodes and other stuff going out to output plug. |
Re: 20484 charger dead
Thanks. Transformer bad
|
Re: 20484 charger dead
1 Attachment(s)
Bummer, all good things must come to an end....eventually.
Since it had at least a 30 year run, its quadrupled the life of today's new ezgo charger. (And that might be giving the new ezgo charger too much credit) Is the the cart it's been charging from the 80's? So, if you see one of these in the used market, unless it's free, avoid it. (And even if it's free, if it doesnt work, you cant fix it either). |
All times are GMT -5. The time now is 01:01 PM. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This Website and forum is the property of Buggiesgonewild.com. No material may be taken or duplicated in part or full without prior written consent of the owners of buggiesgonewild.com. © 2006-2017 Buggiesgonewild.com. All rights reserved.