EZ GO 600CBR 6 Speed gearing question.
Hello everyone. This is my first post so thanks everyone in advance. I just bought a completed 94 EZ GO with a fuel injected 600 cbr engine and 6 speed transmission. This setup was built using the original sprockets off the bike with a live axle. I am going to use this for a sporting clays cart. I am wanting to get this cart geared as short as possible so I can keep 1st gear as slow as possible to haul 4 guys around the course. Does anyone have any suggestions on sproket sizes to get the lowest possible gearing?? I really appreciate the input. Thanks!!!!
|
Re: EZ GO 600CBR 6 Speed gearing question.
Smallest front and biggest rear sprockets you can get will lower the gear ratio, I ran a 13 and a 60
|
Re: EZ GO 600CBR 6 Speed gearing question.
Hi I’ve used standard CBR front and rear sprockets and it’s spot on atm I’ll find out more once I’ve had a good long drive but it’s a decent starting point
|
Re: EZ GO 600CBR 6 Speed gearing question.
I have a stack of sprockets, hubs, from working to figure out what ratio works for Drag Racing, I got the best combination for my engine and axle,,, as far as driving around the Park or neighborhood, good luck with what ever atm is.
|
Re: EZ GO 600CBR 6 Speed gearing question.
Quote:
at the moment :) |
All times are GMT -5. The time now is 07:30 AM. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This Website and forum is the property of Buggiesgonewild.com. No material may be taken or duplicated in part or full without prior written consent of the owners of buggiesgonewild.com. © 2006-2017 Buggiesgonewild.com. All rights reserved.