No power with New 400A solenoid, Navitas conversion w Roy Pow 2009 YDRE
 

I have been running the Navitas controller and motor with the stock solenoid for 1.5 years now and decided on a recommendation to change to the MZJ 400 A. Wired it the exact same and it is dead. Here is the question!
Do I run the positive or negative 2ga off the pack to the solenoid? What goes to the solenoid and what goes to B-?
I know the other side of the solenoid goes to the B+ on the controller.

Re: No power with New 400A solenoid, Navitas conversion w Roy Pow 2009 YDRE
 

Battery positive to the solenoid, solenoid to B+ on controller. Battery negative to B- on controller.

Re: No power with New 400A solenoid, Navitas conversion w Roy Pow 2009 YDRE
 

Well it has been running but... know have a delay when I hit the gas pedal and the battery is overheating and shutting down after about 3 minutes running on the street.