1995 48V won't move
 

My 1995 48V just quit working. The charger won't charge and the relay doesn't even click when plugged in.

The pack reads 51.7 volts.

When the pedal is pressed in either forward or reverse the cart doesn't even budge.

I've checked all wiring and fuses. All cables are new and terminals are clean and tight.

I did have to tighten the OBC nuts a bit as the OBC was a little loose and was maybe bouncing around.

So.... charger isn't charging and the cart won't move forward or reverse.

Any clues?

Thanks in advance.



Sent from my iPhone using Tapatalk

Re: 1995 48V won't move
 

Anything else loose and bouncing around?

Re: 1995 48V won't move
 

No. I just jacked it up and looked all underneath too


Sent from my iPhone using Tapatalk

Re: 1995 48V won't move
 

Do you hear a click when you press the go pedal?

Re: 1995 48V won't move
 

Yes I do. Right where the throttle linkage connects


Sent from my iPhone using Tapatalk

Re: 1995 48V won't move
 

Ok. Raise the seat (jack rear wheels off the ground) is the SOLENOID making a click?

Re: 1995 48V won't move
 

Solenoid near the motor? No. I don't hear anything there. https://uploads.tapatalk-cdn.com/201...71a4b110fc.jpg


Sent from my iPhone using Tapatalk

Re: 1995 48V won't move
 

Yes. That thing. (Bear with me, I'm not the best but it's after 1:00 am on a weekend I might be all you get until tomorrow). Look at the small wires at the forward reverse switch. The thing by your right knee on the INSIDE of the cart. Make sure none of those have worked loose. Check them closely.

Re: 1995 48V won't move
 

Haha. All good. I'll take what I can get. It's 10:20 here. I totally understand. Yes, I've checked those as well. All appear to be good and tight.


Sent from my iPhone using Tapatalk

Re: 1995 48V won't move
 

Wiggle the key switch a few times while in gear and press pedal.