Yamaha electric g9
 

Hey everyone

I purchased a electric g9 that wasn’t running. Have narrowed it down to the speed controller and the throttle position sensor as I have bypassed them at the moment and everything is working at full throttle straight away.
My question is Iam getting a 2kohm reading out of the throttle position sensor.
Is that ok as I thought the g9 where 0-1kohm range and could this cause the cart not to run?
Thanks

Re: Yamaha electric g9
 

I know this probably needs to go on another thread, but I'm in the same boat as you... bought a project. How do I go about testing the speed control and tps? And how do you bypass them to test the motor?

Re: Yamaha electric g9
 

If you want to test the motor and bypass the speed controller, I got some jumper leads connect one side to the negative side of your battery pack and connected other side to the A2 terminal of your motor.
Motor should spin at full throttle.