2011 Lipo Club Car Precident wont run
 

I had it running then added a 48-12v converter to run the lights etc. I bypassed the OBC and the cart wont move. when i press the pedal i hear the solenoid click twice then nothing. any ideas? i am getting 56v on both sides of the solenoid with the key on.

Re: 2011 Lipo Club Car Precident wont run
 

Did you connect the blue and white wires at the OBC? See the below sticky about the OBC bypass procedure

http://www.buggiesgonewild.com/elect...bypassing.html

Re: 2011 Lipo Club Car Precident wont run
 

I connected them at the harness side not the computer side of the harness. is this correct?

Re: 2011 Lipo Club Car Precident wont run
 

Yes.

Re: 2011 Lipo Club Car Precident wont run
 

So i gave up on the stock controller and purchased a 400 amp alltrax controller for an iq cart. I installed it and nothing . when i hook it to the computer it sees teh f/r switch moving but does not see the key as being on. I checked pin 10 and it is indeed getting 56v when i turn the cart on but the controller is not recognizing it. i checked the programming and it is programmed for a club car so i am ready to just burn the pile in the street. anyone out there have any ideas?

Re: 2011 Lipo Club Car Precident wont run
 

Can you give us a screen shot, of the "monitor" tab in the Alltrax toolkit?