97 DS Regen2 Silver Controller Won't Move
Bought not running. Replaced Controller. Charger worked after reviving batteries from total dead with another charger. Tested wiring harness finding microswitch bad in v-glide (now twisted wires together). Bad solenoid, bypassed heavy wires together to power all the time testing on jack. NO GO? Used FX302 troubleshooting guide to verify pin voltages. All sat EXCEPT pin 6(verify approx 30v) had 0v. Mine is not a FX302 it is a silver controller but we were looking for any info we could get to test with. Still NO GO!!!!!!
|
Re: 97 DS Regen2 Silver Controller Won't Move
I have since applied battery pack voltage to pin 6...Still NO GO.
|
Re: 97 DS Regen2 Silver Controller Won't Move
Is this the troubleshooting procedure you were using?
http://www.fsip.biz/Documents/FX302_...egen2_Cart.pdf |
Re: 97 DS Regen2 Silver Controller Won't Move
Yes that is it. We don't have the exact same controller. We were just verifying the harness integrity while trying to troubleshoot.
|
Re: 97 DS Regen2 Silver Controller Won't Move
I'll be glad to help you if I can, but I'm going to require you to fix the problems you find instead of twisting wires together. You may have something as simple as a HPD (High Pedal Detect) because you twisted wires together on the micro. Replace the Micro Switch then we'll work from there.
|
Re: 97 DS Regen2 Silver Controller Won't Move
Will do.
|
Re: 97 DS Regen2 Silver Controller Won't Move
Pulled limit switch. It was sticking. Cleaned switch, now works as it should . Also replaced bad main (only) solenoid while we were at it. Did not have pack voltage to begin with; put on charger for a few min. to wake the OBC, now have pack voltage (51v) but still no go.
|
Re: 97 DS Regen2 Silver Controller Won't Move
Controller doesn't seem to be taking the solenoid to ground to energize run ckt.
|
Re: 97 DS Regen2 Silver Controller Won't Move
This is the diagram we have been using to diagnose. It matches all the components we have.
http://www.fsip.biz/Documents/FX302_R2.pdf |
Re: 97 DS Regen2 Silver Controller Won't Move
Make sure throttle signal is getting all the way back to the controller from the Potbox or V-Glide (Could be either on this model) Also, make sure 48V is getting through the pedal micro switch all the way back to the controller as well.
|
All times are GMT -5. The time now is 11:44 PM. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This Website and forum is the property of Buggiesgonewild.com. No material may be taken or duplicated in part or full without prior written consent of the owners of buggiesgonewild.com. © 2006-2017 Buggiesgonewild.com. All rights reserved.