1993 electric club car
backs up but wont go forward?
|
Re: 1993 electric club car
Fnr switch
|
Re: 1993 electric club car
removed and cleaned the switch , checks ok, but still wont go forward
|
Re: 1993 electric club car
Could be the micro Sw on the FRN Sw with 3 wires attached.
the speed signal to the controller goes thru the micro sw,, one position is for Fwd, the other is for Rvs thru a resistor for slower speed may have bad wire, connection or Sw contacts in the Fwd position |
Re: 1993 electric club car
Does it go in reverse? That front micro switch. That face is talking about is signaling the juice. But if it goes in reverse and not forward wouldn't that be another issue
|
Re: 1993 electric club car
The third is just the half speed switch the front micro is still engaged I thought
|
Re: 1993 electric club car
Check resistance between pin 2 & 3 on the controller
Resistance should vary as you push go. Jack up Rear of cart put in Fwd 0 to 5k Ω in Fwd or remove wires & measure resistance between the wires as you press "go" |
Re: 1993 electric club car
A worn cam on the F+R could trigger the 1st m/s for one direction but not the other. I'd try taking the wires off m/s. Attach a meter and cycle the F+R sw to verify. One of my cams was marginal.
. |
Re: 1993 electric club car
are we sure this is a controller cart ?
|
Re: 1993 electric club car
Quote:
. |
All times are GMT -5. The time now is 08:16 AM. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This Website and forum is the property of Buggiesgonewild.com. No material may be taken or duplicated in part or full without prior written consent of the owners of buggiesgonewild.com. © 2006-2017 Buggiesgonewild.com. All rights reserved.