Voltage Reducer Key Switch Signal
 

Hi Guys, I installed a voltage reducer that has an additional wire that goes to key switch positive to turn it on. The only issue is that the cart I am installing it in has a key switch negative (Cart is wired like the picture I attached). Is it possible to put that wire anywhere else on the cart that will allow the voltage reducer to only run if the key is switched on? I know I can just join in with the pack positive but I rather be able to have it turn on and off with they key.

Re: Voltage Reducer Key Switch Signal
 

This is an interesting question I have thought about but never seen it done.

Pretty sure you could run a relay with a 4 wire reducer, but I don't know about using what you have (5 wire).

Re: Voltage Reducer Key Switch Signal
 

The best solution in the long run is to just convert your key switch to positive.

It is very simple, just follow this post:

http://www.buggiesgonewild.com/elect...ml#post1487837

Re: Voltage Reducer Key Switch Signal
 

I knew you would know what to do! :thumbup: