Buggies Gone Wild Golf Cart Forum

Buggies Gone Wild Golf Cart Forum (https://www.buggiesgonewild.com/index.php)
-   Electric EZGO (https://www.buggiesgonewild.com/forumdisplay.php?f=16)
-   -   Goes in reverse when switch is in forward. does nothing with swicth in reverse (https://www.buggiesgonewild.com/showthread.php?t=91077)

Vvlou 03-06-2014 08:16 PM

Goes in reverse when switch is in forward. does nothing with swicth in reverse
 
I have a 2002 ezgo. I just replaced the brushes in the motor. It has been sitting for awhile before I fixed it. When I put the direction switch in forward the cart backs up. When I place the switch in reverse I hear the solenoid click but it does not move. The batteries are good and fully charged. I'm at a loss. Any help would be greatly appreciated. Thanks

criley 03-07-2014 07:43 AM

Re: Goes in reverse when switch is in forward. does nothing with swicth in reverse
 
Quote:

Originally Posted by Vvlou (Post 995289)
I have a 2002 ezgo. I just replaced the brushes in the motor. It has been sitting for awhile before I fixed it. When I put the direction switch in forward the cart backs up. When I place the switch in reverse I hear the solenoid click but it does not move. The batteries are good and fully charged. I'm at a loss. Any help would be greatly appreciated. Thanks

I assume you had the motor out?

I'm not a golf cart expert by a long shot, but if it were me, I'd double check that all the wires are connected to the correct places.

JohnnieB 03-07-2014 08:19 AM

Re: Goes in reverse when switch is in forward. does nothing with swicth in reverse
 
1 Attachment(s)
Could be two separate problems.

1. Runs in Reverse when direction selector in in Forward. Either the A1 & A2 cables or the S1 & S2 (or F1 & F2 cables if it is a Sepex motor) were reversed when they were reinstalled.

2. Runs in one direction, but not the other. What is causing this problem depends on which type drive system you have PDS or Series.

Figure out what you have from the attached chart, let us know and we'll proceed from there.

Vvlou 03-08-2014 07:00 AM

Re: Goes in reverse when switch is in forward. does nothing with swicth in reverse
 
I have the PDS.

JohnnieB 03-08-2014 09:48 AM

Re: Goes in reverse when switch is in forward. does nothing with swicth in reverse
 
Ouch, the F/R switching is done by the controller. (Reverses direction of current flow through the Field windings)
You might have a bad controller.

Hopefully, you put the Run/Tow switch in Tow while disconnecting and reconnecting the motor cables.

Vvlou 03-11-2014 05:37 PM

Re: Goes in reverse when switch is in forward. does nothing with swicth in reverse
 
Thanks guys. Is there a way to test the system with a multi meter?

scottyb 03-11-2014 06:11 PM

Re: Goes in reverse when switch is in forward. does nothing with swicth in reverse
 
If it's going in the wrong direction in one selection and not moving in the other selection it's a common controller failure like Johnnie said. Time for an upgrade.


All times are GMT -5. The time now is 04:38 PM.

Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This Website and forum is the property of Buggiesgonewild.com. No material may be taken or duplicated in part or full without prior written consent of the owners of buggiesgonewild.com. © 2006-2017 Buggiesgonewild.com. All rights reserved.