bore out on G16
Anyone know if there is a ring and piston set for .10 over? JN-6 301 motor!!:oops:
My dads yami!! Overheated and warped. |
Re: bore out on G16
I don't think you will find .100 O/S. I believe .050 O/S is max. But, I could be wrong.
|
Re: bore out on G16
Sorry guys my typo.......... .010(ten thousanths) OB we measured it at about .007 out of round
looking to take off minimal material if possible |
Re: bore out on G16
G16's only have to oversided pistons available, .25 and .50 over. Standard bore 74.96mm-74.98mm, oversized 1-75.25mm and oversized 2-75.50mm. Rons right:wink:
|
Re: bore out on G16
My dimwitted fault......didn't realize until I saw it closer it was mm and not standards....
.25mm is at .0098 thousanths, I'm good to go! Will boring out and installing larger piston & rings change much with carb mix? Is there a posting and /or shop manual recommended for the reassembly of the 301 motor? |
All times are GMT -5. The time now is 09:40 AM. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This Website and forum is the property of Buggiesgonewild.com. No material may be taken or duplicated in part or full without prior written consent of the owners of buggiesgonewild.com. © 2006-2017 Buggiesgonewild.com. All rights reserved.