I need wiring help please
 

Hello all, hope someone can help I have a 1995 cc and the curtis controller that was on it has four terminals, the fourth being A2 with a white cable from f/r and a white cable to A2 on motor. So I ordered a alltrax controller with the A2 terminal. (plug brake) but the alltrax wiring diagram shows only 1 wire coming off of A2 going to motor and another wire from motor A2 to a reversing contactor which my cart didn't have

The wiring diagram in the stickys doesn't show a termial A2 on the controller
or a second contactor .(white wire from f/r staight to A2 on motor)

how should I wire this thing up?:help::help::help:

Re: I need wiring help please
 

wolf, where you at in pittsburgh? i,m south of bridgeville in cecil...........your cart the altrax controller didn,t have an A-2 stud right......it came with just 3 studs instead of 4................if thats the case the 2 cables that were mounted to the A-2 stud on the curtis what you do is bolt them 2 togather and tape them up real good than secure them somewhere so they arn,t just flopping around because they arn,t used on the alltrax..........also make sure you use the 250 amp fuse that came with it.........if you look at the quick install guide they sent you with the controller it tells you just what to do........................................8)

Re: I need wiring help please
 

hey thanks shadowman I'm in west mifflin near co. airport. this is my first build and it's been a real learning experience I've learned alot from this forum. I ended up calling alltrax they said f/r to controller A2 then to motor A2 the same way it was. I was confused because wiring diagram in sticky doesn't show A2 on the controller. anyway time to tackle the next problem larger cable and lugs getting them on the heavy duty f/r switch!

Re: I need wiring help please
 

good luck and we are here if we can help...........i know just where the airport is up there......................................8)