Don't laugh...
Ok folks please be kind here.
Has any anyone ever shorten the steering wheel column on a CC DS? I find mine to be 2-3 inches too long. M |
Re: Don't laugh...
I'm not laughing, the column is too long for me too!
I've read where some have done it, but I cannot remember where - I'll see if I can find it. |
Re: Don't laugh...
Here we go.
Seems when someone asks about it folks get all excited about cutting what you want off of it from one end, then having it re-splined. If done correctly, however, you can remove the length you don't want from the center and re-weld it AT YOUR OWN RISK because if you don't do it right it can be UNSAFE. (Gotta put in the disclaimer, I'm sure you know these things, but one can never be too careful) Here's the info from Pachanga90: If you get a weldable shaft collar(about 2" long)you can cut the shaft in the center, remove the amount you need shortened, then reassemble the shaft. Be sure to center each half in the collar(1" each).If you aren't an experienced welder have someone who is weld the shaft for you.(I wouldn't suggest a cheapie 110volt welder for this, you need a good, well penetrated weld, this is your life you are playing with).If the collar is for example,1/4" wall, then get some spacers also 1/4" and lay the shaft in a piece of straight angle-iron to act as a "V"-block so it comes out straight. Then just cut down your cover-tube the same amount. Hope this helps. |
Re: Don't laugh...
Would it be great if someone had a kit you could buy...
M |
Re: Don't laugh...
I'd like tilt steering myself, it is too upright for me.
|
Re: Don't laugh...
Quote:
|
Re: Don't laugh...
No I haven't probably expensive also.
|
Re: Don't laugh...
Not sure why carts are all One Size Fits All. I have short legs and my wife's are even shorter. She has to sit on the edge of the seat to drive our cart.
|
Re: Don't laugh...
anyone know where to get one of the collars?
|
Re: Don't laugh...
not done this .. but .. having welded pipe before you can cut column to size and then V grand the ends ½" and weld joint ... grind flush ... strong as new
http://3.imimg.com/data3/HX/FF/MY-63...ce-500x500.jpg |
All times are GMT -5. The time now is 05:46 PM. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This Website and forum is the property of Buggiesgonewild.com. No material may be taken or duplicated in part or full without prior written consent of the owners of buggiesgonewild.com. © 2006-2017 Buggiesgonewild.com. All rights reserved.