DS IQ new Alltrax fault code.
This cart got flooded a little and the controller was obviously toast when the owner brought it to me. I tested the motor both continuity and with power. Motor ran fine. Installed a new XCT. Cart ran great. Then all of a sudden I'm getting a one green one red code which says open, or short circuit. I removed the motor, cleaned and inspected ( I suspected corrosion or stuck brushes) all looked good. Continuity between A1 and A2, continuity between F1 and F2, open from A to F and open to the casing. Reinstalled the motor, and get the same code. What am I overlooking? I hate to buy a motor if it's good. I'm gonna retest it with power later and see if it runs.
Thanks! Sent from my SM-G930R4 using Tapatalk |
Re: DS IQ new Alltrax fault code.
Corrosion in wiring other than the motor? Main wiring harness, batteries?
|
Re: DS IQ new Alltrax fault code.
Quote:
Sent from my SM-G930R4 using Tapatalk |
Re: DS IQ new Alltrax fault code.
Can anyone tell me what ohm reading I should get between A1 and A2, and between F1 and F2? I have continuity between them. I check the ohms and get 2.9.
Sent from my SM-G930R4 using Tapatalk |
Re: DS IQ new Alltrax fault code.
I removed all the cables from the motor, doublechecked motor continuity. Applied 12 volt to the motor and it runs fine. Hooked the controller back up and left the control lose face up to test and runs fine. Mounted it back and get the same thing. Must be something in the harness, I just have to find it. All looks good.
Sent from my SM-G930R4 using Tapatalk |
Re: DS IQ new Alltrax fault code.
Quote:
|
Re: DS IQ new Alltrax fault code.
I just got off the phone with Ron at Alltrax, and after a few test that he had me run, it turns out that the new controller is faulty. He had me to disconnect the M- which takes the motor out of play, and I was still getting the code. They have me another on the way. Great customer service!
Sent from my SM-G930R4 using Tapatalk |
Re: DS IQ new Alltrax fault code.
Quote:
|
Re: DS IQ new Alltrax fault code.
Quote:
Sent from my SM-G930R4 using Tapatalk |
All times are GMT -5. The time now is 10:58 PM. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This Website and forum is the property of Buggiesgonewild.com. No material may be taken or duplicated in part or full without prior written consent of the owners of buggiesgonewild.com. © 2006-2017 Buggiesgonewild.com. All rights reserved.