2001 PDS Issues
Hello,
I had my A1 terminal on the controller and motor get super hot which melted the wires a bit on each side. I've since upgraded all the cables to 2 gauge. But since I installed the new cables, the direction of the cart has reversed. When I set the switch to forward, the cart goes in reverse and when I set the cart in reverse the cart goes forward and the reverse buzzer goes off and it seems to only go reverse speed (or at least its slower then I'm used to). My first thought is I reversed polarity somewhere but after looking at some diagrams it doesn't appear to be. Any ideas? Thanks! |
Re: 2001 PDS Issues
A1 and F1 connect to the motor towards the front of the cart. A2 and F2 towards the back.
Sent from my SCH-I545 using Tapatalk |
Re: 2001 PDS Issues
Yes, that's just how its hooked up. On the motor I replaced one cable at a time to make sure they were not crossed. And I did not replace or disconnect the F1 or F2 cables.
|
Re: 2001 PDS Issues
You have some wires reversed somewhere. Reverse the F1 and F2 wires and you will be good to go
|
Re: 2001 PDS Issues
Quote:
|
All times are GMT -5. The time now is 02:28 PM. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This Website and forum is the property of Buggiesgonewild.com. No material may be taken or duplicated in part or full without prior written consent of the owners of buggiesgonewild.com. © 2006-2017 Buggiesgonewild.com. All rights reserved.