how do i replace this bearing in my pds motor
how do i get this thing apart to replace the bearing,, 2004 pds ez-go,, i have it pulled and apart exept the armature to the cast housing
|
Re: pds motor , replace bearing how do i do it
anyone know how to get to this bear:roll::roll::shock:ing
|
Re: pds motor , replace bearing how do i do it
Pull the armature out, use a bearing puller and pull the bearing off and install new bearing. Its a simple operation
|
Re: pds motor , replace bearing how do i do it
the armature seems to be stuck in the cast housing , is there a hold down plate for the bearing behind the brush assembly or do i need to use a bigger hammer on the arm. shaft where the magnet for the speed scensor attachesand beat it out??
|
Re: pds motor , replace bearing how do i do it
what motor is it? The end cap should tap off once you removed the screws that hold the bearing plate to the motor
|
Re: pds motor , replace bearing how do i do it
The bearing in a PDS motor has to be pressed out.you might want to take it to a machine shop and have it done unless you have a arbor press.
|
All times are GMT -5. The time now is 09:08 AM. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This Website and forum is the property of Buggiesgonewild.com. No material may be taken or duplicated in part or full without prior written consent of the owners of buggiesgonewild.com. © 2006-2017 Buggiesgonewild.com. All rights reserved.