can the two copper bolts on the forward reverse switch be replaced
 

I have an ezgo with a forward reverse switch- not a rocker switch-
thw two copper bolts are damaged- can the copper bolts be replaced?
or should I say can I replace the two copper bolts that hold te power cables

Re: can the two copper bolts on the forward reverse switch be replaced
 

Either way you say it the answer is YES 8)

Check our sponsers or google copper contact stud ......

Re: can the two copper bolts on the forward reverse switch be replaced
 

OK I have ordered new copper studs- from a board sponsor

any suggestions on simpler removal?
I thought about soaking the studs down with JB rust blaster and letting it sit for a least a couple of hours and then going real slow
apply heat or not?
thanks

Re: can the two copper bolts on the forward reverse switch be replaced
 

A solvent is good but don't try to operate it with that stuff on it as all of those products a highly flamable in the presence of electrical spark :thumbup: Anyway it is all copper bolted thru fiber board.......no rust involved. Just corrosion. I suggest removing the F&R to replace the studs...

Re: can the two copper bolts on the forward reverse switch be replaced
 

If your studs are not completely damaged you might be able to file them down. They are solid copper, so as long as they are making good contact, current should flow. If they continue to crap up, you might have another problem. I had a broken resistor that kept fouling my speed board contacts, so it could also effect your FNR switch. Good luck. Of course disregard this post if you have a controller cart.

Re: can the two copper bolts on the forward reverse switch be replaced
 

I thought about mentioning that too Mike but, it is hard to get them flat to make good contact and he was already looking for new which guarrantees good contact once installed....8)