1997 48v Power drive (not plus) Wiring diagram
I am a new owner and new here. I tried to do some reading and searching before asking a question, but I need to post.
I picked up a 1997 48v Club Car for my new home in the country. The prev owner had put a lift kit on it and it runs fine. I've owned it about a week and my daughter noticed smoke coming from the battery area. It looks like the smoke is coming from inside the positive battery terminal cable. Aside from this, I immediately noticed 2 things: battery terminals with a fair amount of corrosion, and at least 2 wires that have been disconnected from *somewhere*. I am going to mix up some water and baking soda to care for the terminals and maybe end the smoke from the positive terminal cable (I am assuming the terminal is getting too hot and is heating up the plastic). However, for the disconnected wires, I need to find a schematic for a 1997 48v Power drive Club Car. I've seen a Power drive Plus schematic posted here, but not a Power drive, is the wiring different? Any pointers or advise is welcome. thanks Sent from my KFFOWI using Tapatalk |
Re: 1997 48v Power drive (not plus) Wiring diagram
Baking soda is old school- just hose it down with a hose, youll get the same results and not run the risk of damage to your batteries.
The smoking terminal is a concern, its a loose connection- needs to be repaired and make sure it is tight. |
Thanks. Now... the terminal itself is not smoking, it is coming from the cable connected to the positive terminal. I will double check if it is loose just the same.
Sent from my KFFOWI using Tapatalk |
Re: 1997 48v Power drive (not plus) Wiring diagram
You definetely have to use baking soda, its purpose is to neutralize the acid, otherwise you are just spreading the acid around.
Either way do it away from any area that can be stained, specially concrete driveways. This diagram should match if you have the CVP (Continously variable Potentiometer). http://www.buggiesgonewild.com/attac..._96_ds_cvp.jpg |
Re: 1997 48v Power drive (not plus) Wiring diagram
2 Attachment(s)
Sergio - I got "404 not found" on your link - not sure if that happened to OP. I've attached both the CVP and Multistep (from my '96 manual) below. Somehow, I think '97 was Multistep. Hopefully one of these will match his cart.
|
Re: 1997 48v Power drive (not plus) Wiring diagram
Quote:
|
All times are GMT -5. The time now is 07:07 PM. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This Website and forum is the property of Buggiesgonewild.com. No material may be taken or duplicated in part or full without prior written consent of the owners of buggiesgonewild.com. © 2006-2017 Buggiesgonewild.com. All rights reserved.