Motor to controller cables.
Any advice on what cables I need to run for upgraded controller? My stock are heating up.
Precedent 400 Amp upgrade Sent from my SM-G950U using Tapatalk |
Re: Motor to controller cables.
The 6 gauge cables that go to the A1 and A2 are the most important cables to upgrade as they always carry 100% of the motor current. All of the other cables only carry 100% of the current when the Controller is at 100% output. Me personally, I would upgrade all of them if for no more then reliability and uniformity. Especially the battery cables....
|
Re: Motor to controller cables.
Battery cables are 00 already, but I need to upgrade the motor to controller and what to do for the solenoid cables?
Sent from my SM-G950U using Tapatalk |
Re: Motor to controller cables.
2 gauge cable is more than enough...
|
Re: Motor to controller cables.
After you upgrade the A1 & A2 cables to the motor don't discard the old number 6 cables. Use them to upgrade the F1 & F2 cables to the motor.
|
Re: Motor to controller cables.
"F" cables are low amp cables 10 ga is all you need even if you have Big controller.
|
Re: Motor to controller cables.
Yes, they only send directional current.
|
Re: Motor to controller cables.
What's best gauge for the motor cables and best length for lifted cart
Sent from my SM-G950U using Tapatalk |
Re: Motor to controller cables.
Anyone?
Sent from my SM-G950U using Tapatalk |
Re: Motor to controller cables.
Quote:
|
All times are GMT -5. The time now is 09:23 AM. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This Website and forum is the property of Buggiesgonewild.com. No material may be taken or duplicated in part or full without prior written consent of the owners of buggiesgonewild.com. © 2006-2017 Buggiesgonewild.com. All rights reserved.