New goodies from PQ
 

Well Guess I'll make a thread of this build, PQ has hooked my up with some nice parts, now I just need to install!

Re: New goodies from PQ
 

We're expecting a gain from 19 mph to about 24 mph & at least 50% more torque, I think what he said. I'm waiting to get info on if I need the resistor & diode anymore or not with this set-up. I'll GPS the speed once done, I'd like to just upgrade the motor clock it then do the controller upgrade but I want to make sure they are ok with that first.

Re: New goodies from PQ
 

After reading up looks like the controller has the pre-charge resistor built in and the adaptor board has the diode, I should be set.

Re: New goodies from PQ
 

Nice, can't wait for results...:thumbup:

Re: New goodies from PQ
 

The controler says D&D motor systems, but it's clearly an alltrax, and it came from plum quick?

Re: New goodies from PQ
 

Yup, it says alltrax on the side but D&D supplies them & PQ programmed it for my application.
I need to check the settings out but I'm tapped out on this cart right now, will have to do it later unless someone has a poor mans way of doing it. The software is free and i have it, I just need to interface with the controller.

Re: New goodies from PQ
 

No need to mess with it really. It looks like the PQ motor uses the same field maps used for the D&D 502 motor. D&D is an Alltrax Distributor. They buy in large quantities and Alltrax programs and prints labels for these large orders.
PM sent

Re: New goodies from PQ
 

I'm pretty sure you need the diode and resistor on the solenoid.

Re: New goodies from PQ
 

Not according to the instructions from Alltrax/D&D but it was clear that if you left them it wasn't an Issue, maybe I should scan the booklet, It may be useful.

Re: New goodies from PQ
 

Im not sure what you are looking at but the Alltrax manual recommends at lease a 100v 1A diode on the solenoid.