V- Glide to Pot box
Is it possible to use a pot box. pb6 on a resistor cart?
|
Re: V- Glide to Pot box
Yes, you will need a compatible controller and some other items. Search " resistor to controller " in this forum. There are several posts on doing this! :mrgreen:
|
Re: V- Glide to Pot box
Quote:
The potentiometer is the peddle position indicator and throttle signal input device (ohms) for electronic speed control. The V-glide is a terminal selector type wiper switch which routes high amperage current through one resistor or another. I hope this helps. |
Re: V- Glide to Pot box
Yes it does thanks alot. looks like ill be looking for a used controller box. a pre mcor controller from lets say a ezgo work?
|
Re: V- Glide to Pot box
The pot output must match the control input. the control output must match the motor demands = the work load .... you are going about this the long way :lol:
It can be done but remember controller damage is accumulative, beware of buying somebody else's problems. Typically, stock controllers are not big enough for off road use. Ezgo used pot compatible controllers from 1989-94 in the 350 amp range..... smaller than the typical recommended 400 amp aftermarket control. |
Re: V- Glide to Pot box
that is exactly what i needed to know. well i plan to run a four seater around town. but in the distant future i would like to lift the cart. not any off road really but i would like speed. 15+ I just don't care for paying $400 for a controller. but a stock ezgo will get me by for a while right?
im still better off than keeping the good ole fashioned resistor set up? I pushed my resistor carts in the past pretty hard. |
All times are GMT -5. The time now is 04:14 AM. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This Website and forum is the property of Buggiesgonewild.com. No material may be taken or duplicated in part or full without prior written consent of the owners of buggiesgonewild.com. © 2006-2017 Buggiesgonewild.com. All rights reserved.