Alltrax failure lots of smoke
1 Attachment(s)
So i finally got it all wired up and put back together. When i went to give it gas it hesitated I put it in reverse then it took off burning the tires right through the garage door. What a mess. So i pulled it back apart and this is what I found see on the right the diode wire burnt up but there was a lot of smoke what do you think all got damaged. This was definitely a mistake my garage door is beond repair *** and there is 2 of them so it looks like i will be buying 2 doors to make them match. http://www.buggiesgonewild.com/attac...1&d=1533791404
|
Re: Alltrax failure lots of smoke
Quote:
|
Re: Alltrax failure lots of smoke
Diode was backwards, stripe should be on the hot side as noted in the responses in your various other threads.
How on earth is you garage door fubar from a cooked diode hooked up wrong? Your cart should run fine without it too, just don’t shut the key off in regen. |
Re: Alltrax failure lots of smoke
Both diodes are on backwards.
|
Re: Alltrax failure lots of smoke
Quote:
|
Re: Alltrax failure lots of smoke
And out of curiosity, why do you constantly start multiple threads on the same topic? If you are trying to bump your post count there is a specific thread already for that.
|
Re: Alltrax failure lots of smoke
Yes, keep all your threads together on the same topic so everyone trying to help can get all the facts in ONE place.
As mentioned by E36, your diode is definitely backwards but that doesn't explain why your cart took off at WOT. For safety reasons, it's best to ALWAYS check you work with 1 wheel off the ground to avoid $$$costly$$$ instances like you experienced. Good news is, the Alltrax has reverse polarity protection so it should be fine. |
Re: Alltrax failure lots of smoke
Quote:
|
Re: Alltrax failure lots of smoke
Just trying **** like flipping a diode is not the right way to do electrical work.
It sounds like this cart should be put in the hands of somebody who can read a wire diagram. You can remove the small solenoid diode and see if the solenoid clicks when you press the gas WITH THE CART ON JACK STANDS If no click the MCOR micro switch may be burnt out now. I'm curious how the cart took off full throttle? Can you verify the year and drive system of this cart? IQ? What is the blink code when the gas is pressed and the solenoid just clicks? this green blink code will indicate the throttle setting. |
Re: Alltrax failure lots of smoke
Ok the cart seems to be running fine now way more torque. The only problem I have now is the headlights and tail lights not working. I have power at the fuse. I know this cart has a voltage reducer. Any ideas. I don’t think there is power coming out of the reducer there is a fuse there which checked good so I got power to the first fuse in the bucket harness but no power coming out I think I smoked the reducer. There is no power at the USB ports either. I can get another reducer but will it pop also am I wired wrong why didn’t the fuse blow.
|
All times are GMT -5. The time now is 09:14 AM. |
Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
This Website and forum is the property of Buggiesgonewild.com. No material may be taken or duplicated in part or full without prior written consent of the owners of buggiesgonewild.com. © 2006-2017 Buggiesgonewild.com. All rights reserved.